DescriptionClip specifically developed for panel claddings installed on masonry walls, half carrying; designed for medium loads, longitudinally ribbed in order to provide higher strength and stiffness. The connection to the supporting structure is performed by making a drill hole with a diameter of approximately 30/35 mm for models GR-AM-V and GR-AM-R and of 8/10 mm for the model GR-AM-HOR. Subsequently, the waste material must be removed, carrying out a mortar filling with non-shrink additives. In the case of the model GR-AM-R, the connection to the panel cladding is made through a circular cut in the thickness of the panel and the introduction of a clip with a forward bending (see description). In the models GR-AM-V and GR-AN-HOR, the connection is made through a drill hole in the thickness of the panel and the subsequent introduction of a push rod. In all three cases, it is necessary to fill the rear side of the panel with MCP-mortar (or similar), according to specifications. In the case of model GR-AM-NEW, a more discreet anchoring (visible or hidden) has been developed for use with porcelain materials, with an installation procedure similar to that for GR-AM-R. In all four cases, it is necessary to fill the rear side of the panel with MCP-mortar (or similar), according to specifications.
Features- Specifically designed for masonry façades
- Suitable for all enclosure walls
- Easy installation
- Machining with drilling and slots.
Download Fact Sheet